[NBA] UPS for my PC

[randomdude]

I wanna power 1 fan 1 light and pc and 23 inch lcd. These are the pc specs:
i5-2500K
z68 ex3 gen3
500GB hdd
8gb@1600 ram
gtx 570
hyper 212
dvd rw

First time I am buying a ups so please advise me on how much battery I would need and the costs etc.

 

[JJDoctor]

Buy homage 1000 (600w) along with it IT-1500 battery by Volta...
Total cost ~ 20k..(9k ups & 11k battery)

Been using for last 2 yrs and i am quite satisfied...

 

[randomdude]

What stuff did you power with that setup and how long did it take for ups to run out of juice? I need 1hour of power at least. 1 to 1 and a half.

 

[Serious Sam]

Main thing is UPS. If its not efficient and let say its rated Wattage is way over your setup, then efficiency will decline.

Backup depends on the batteries. Just keep adding them until your desired time is achieved. Don't go over 155A for each battery as maintaining them and handling them will get extremely hard.

 

[randomdude]

Hmm... any idea of how big a battery i should buy?

 

[Serious Sam]

Two 155Ampere minimum for gaming. One is fine if you are browsing and watching movies. That if only PC is connected to ups and not speakers, monitor etc.

1 hour backup only if fully charged.

 

[randomdude]

Will 22000 be enough for UPS and batteries?

 

[Serious Sam]

If 1 battery, yes.

 

[shad0w]

Why is everybody suddenly recommending Homage and Inverex for Computers and sensitive electronics?

Aren't Homage and Inverex offline UPS?

Whereas XPERT and APC are online UPS, which run on the battery the whole time, while charging it when there is power.

Don't the Offline UPS have a problem when they turn on/changeover to battery power? Like a fluctuation? Do they need a servo stabilizer in between?

 

[shad0w]

Why is everybody suddenly recommending Homage and Inverex for Computers and sensitive electronics?

Aren't Homage and Inverex offline UPS?

Whereas XPERT and APC are online UPS, which run on the battery the whole time, while charging it when there is power.

Don't the Offline UPS have a problem when they turn on/changeover to battery power? Like a fluctuation? Do they need a servo stabilizer in between?

I was expecting and wanted a reply for this post!